Sunday, 18 December 2011

T-Shirt Pillow

Hey everyone,

So I don't know if you have every watched Zoom or remember this show (it was on PBS kids) follow the link for a reminder Zoom. Any ways when I was little I remember watching this show and they made the coolest thing ever. It was a pillow out of a t-shirt. The steps are really simple to following and you'll never have to throw out your favourite old t-shirt again :)


Materials required:
- a t-shirt
- pillow stuffing (if you don't want to buy any, you could open and old pillow that is stuff in the back of your closest and that you will never use again.)
- a sewing machine (this is not required but will make the job go by a lot faster)
- thread (same colour as your t-shirt) and a needle

Step1: Take you t-shirt and turn it inside out. Sew at the arm holes and the bottom hole, this will leave only the head hole open.

T-Shirt is inside out
Step 2: Turn your t-shirt the right way around and stuff the t-shirt until you do not have any stuffing left or it is as full as you want it to be.
The pillow is now stuffed.

I whip stitched the top
Step 3: Whip stitch the head hole close. To whip stitch what you must do is thread your needle. From the one side of the hole (side A) you must bring your thread to the other side (side B) going over top of the hole and then bring it back to side A going below the hole. This is hard to explain 9if you understood what i wrote then Congrats otherwise here is a link to some instructions.

Note that you would use the sewing machine in step 1, but if you do not have a sewing machine that you need to whip stitch the 3 holes closed. Also please make sure that you know how to use a sewing machine safety before using one, they can be tricky sometimes.When using a sewing machine if you have to thread the needle make sure that the machine is off first so that you do not injury yourself while threading the needle.

My T-Shirt Pillow!!

Wednesday, 14 December 2011

Fireplace

This past weekend I released that it is 2 weeks till Christmas and my house is still not decorated (I know sad, right?). Any ways I have this vision in my mind and it was to make a fireplace. So it's time to take action!!

I went to Dollarama (a great place to get a lot of craft supply for a cheap amount). Here I got 4 bristol boards (black, yellow, gold, and orange) and 5 stockings (this is optional). When I got home, I cut out the gold bristol board to the size of the fireplace that I want and put the black bristol board behind it. FREE HANDED I drew a flame on the yellow bristol board and highlighted it with the orange bristol board (however you can't really see it in the picture below). With the left over gold/ brown bristol board (the part that I cut out) I made it into logs to go under the fire. Finally, with a sharpie I drew in the bricks and the logs (so it looks as real as it can). I then put it up on the wall, added the stockings, and put up red Christmas lights underneath to give it a fire look in the dark.

Here is what it looked like at the end.





So, in the end of this post I just want to say that if you image it you can make it possible (whether it is or craft or not).

Thursday, 8 December 2011

Making a HAT!!

Hey everyone,

The first craft that I am going to share you is how I make knitted hats. Now these hats are really easy to make and they take about a day (depending on what size hat you make). Some may even take only a couple of hours.

So I start off with the following: Yarn, a Loom, Tape Measure, Yarn Needle, and a Hook.




Now that I have gathered all the material, I am able to start making a hat.



Step 1: I took the inside of the yarn and pull it out (so that I don't run into knots in my yarn while knitting). Starting at the peg of the side of the loom and wrap the yarn counterclockwise around each peg.

Step 2: Repeat step one so that know there are 2 layers of yarn.


Step 3 is to bring the lower row of yarn above the top row (using the hook) so that there is only one row. Once a complete circle has been made, the yarn is pushed down to the bottom so that is is now the first row of yarn.




Step 4 is to repeat step 2 and 3 were repeated until I had about 4 inches that were knitted







Step 5 bring the lower edge of the now knitted yarn and place them over the pegs. This created the bream. So it looks like the following.
From Above

From the side












Step 6 was to repeat step 2 and 3 again, but now until I have approximately 8-9 inches (this doesn't really matter, for this hat I did 10 inches)

Step 7: Now that the brim is  made and that the hat is the right length. I can begin to take the hat off the pegs. About 18 inches of yarn was cut off from the end and was threaded through the needle. One peg at a time the needle was threaded through the pegs collecting all of the loops on each peg together.



This is half way done
Once all the loops are off, I find that I have a hole at the top of my hat. So I pull the yarn tight and make a knot...and Voila, I have a hat :)

My holey hat
The Finished Outcome!!












If you would like to make a hat like this, you can buy all the supplies at your closest Michaels store. You will get 4 looms (of 4 different sizes) a needle and a hook in one package.

Tuesday, 6 December 2011

What is this blog about...

So I really wanted to start blogging but I didn't know what I should blog about. So, one night I was working on this craft and I thought that it would be neat to track my progress, which is when I decided to blog about the crafts that I am doing . So this blog is all about the crafts I do. There will probably be more pictures than words but I don't see that as a problem.


I hope that you enjoy by blog and will follow.


Sincerely,
Sarah